Features
Power_electronics Features

Power GaN can revolutionise the industrial world - issue 3/2019
Industry 4.0 brings rise to an era of smart factory floors that synergize mass production capabilities with automation, robotics and M2M communication....
More details...
Linear voltage regulators operate at automotive temperatures
Designed for high reliability, high temperature applications, the CMT-Antares is Cissoid's latest regulator.
More details...
Power Electronics Europe News
 
Low-power, digital polar transmitter meets protocol for long range Wi-Fi

imec and Holst Centre presented the transmitter at this month’s IEEE International Solid-State Circuits Conference (ISSCC 2016). It is claimed to have a 10-fold power reduction, compared with OFDM transmitters.

At the Consumer Electronics Show (CES 2016) in January 2016, Compared to other IoT standards, its sub-GHz carrier frequency and mandatory modes with 1MHz/2MHz channel bandwidths allow devices to operate in a longer range with scalable data rates from 150kb/s to 2.1Mb/s. The standard uses OFDM to improve the link robustness against fading, which is important in urban environments, and to achieve a high spectral efficiency (data rate over a given bandwidth).

The polar transmitter meets the tight spectral mask and error-vector-magnitude (EVM) requirements of conventional Wi-Fi standards, while the measured phase noise at 1.5MHz offset is -115dBc/Hz which is 15dB lower than the spectral mask requirement for the IEEE 802.11ah standard.

(The Wi-Fi Alliance introduced the HaLow designation for the new low power, long range Wi-Fi protocol IEEE802.11ah at CES (Consumer Electronics Show) in January. It is a protocol optimised for IoT applications.)

Both the far-out and close-in spectrum of the transmitter pass the mask with at least 4.8dB margin. The EVM is below 4.4%. The power consumption of the transmitter is as low as 7.1mW, when delivering 0dBm output power and operating from a 1V supply. This represents a 10-fold power reduction compared to OFDM transceivers, says the research centre, enabling the prototype transmitter chip to meet IoT application requirements.




View PDF
 
Go Back   
Newsletter sign up

Sponsors