Power_electronics Features

BEV advancements are driving sales, but vehicle safety and reliability will ensure long-term viability
Innovative power architectures using power modules provide power redundancy and improve overall safety and system performance By Patrick Kowalyk, Automotive FAE,Vicor
More details...
AC/DC power factor correction module offers up to 1,512W
A full brick package developed by TDK-Lambda, the PF1500B-360, is for high voltage distributed power architectures
More details...
Power Electronics Europe News
Voltage detection extends battery cell life

It is designed for use in rechargeable Li battery packs, in portable equipment such as smartphones and cameras. Its accurate monitoring capability delivers safe charging and discharging, prolonging cell lifetime and minimising energy losses, says the company.

The device packages a Li protection circuit with a dual N-channel, common-drain MOSFET that can be rapidly turned off when over-charge voltage or current, over-discharge voltage or current, or load short-circuit conditions are detected. A stable temperature-co-efficient characteristic contributes to the voltage-detection capability, which can be set within voltage ranges as required by the end-application. There is also an integrated fixed detection delay time to reduce external component count.

Quiescent current is low, 3.0µA at 25°C in normal mode (typical), and the MOSFET has a low RSS (ON) of 13.5mΩ (typical, for power saving. A power-down mode further cuts the quiescent current to below 0.1µA. The high-voltage CMOS process used enables the device to endure voltage surges up to 30V.

The AP9214L is available in a DFN2535-6 package, with a maximum height of 0.6mm.


View PDF
Go Back   
Newsletter sign up